Metal Rolling Machine Repair / Breakdown / Servicing & Support


JPS Machinery boast the Largest Dealer Service Team in the UK and can cater for all new & used metal rolling machinery through our in house service team.


Typical Metal Roller Service Requirements:

At the beginning of the work shift, inspect the Metal Rolling machine a visual inspection of all areas will allow you to notice and address small issues before they become significant problems

It is important to understand the function, design, and operation of your Metal Rolling Machine

The operators role in service / maintenance of a Metal Rolling Machine is a major part of keeping the equipment running efficiently. It is important to immediately investigate strange noises, vibrations, or something that doesn’t look right. The quicker problems are detected and corrected, can often mean a less expensive fix.

 it’s the small preventive measures that keep a Metal Rolling Machine up and running. 


A daily maintenance check list should include the following:

We have identified preventive measures that are essential to keep a Metal Rolling Machine
up and running.

A service / maintenance / check list should include the following key areas

Clean Hydraulic oil is the key to a healthy hydraulic system. Dirt particles may enter the hydraulic tank. Keeping the oil clean and filling the reservoir to capacity are critical, re filter the oil every 6 months using a 10/15 micron filter, completely replace the oil around 2/3000 hours of actual use

But clean the tank and replace the suction filters before replacing the hydraulic oil

Every 2000 hours grease all nipples

Check all external cables and switches fittings for damage

Calibrate the side roll axis

Adjust the drop end bearing closure

Clean longitudinal & cross travel rails

Electrical Systems:

Emergency stop buttons, check the dual circuits relays, check the safety relay, look for welding of contactors

Check all terminal strip connections , relays, terminal boxes on motors.

Reseat all printed circuit boards and check for physical damage (cracked solder points, burned parts, etc.).

Check all voltages coming from power supplies and transformers.

Check all external cables and switches fittings for damage

Check control panel cooling fans are operational.

Clean control cabinet to remove dust particles